Design process
From FridaV
The box is designed in two halves, each consisting of two parts. It uses similar technology as bicycle helmet - hard shell outside with with hard styrofoam inside, to hold and protect the insides... | The box is designed in two halves, each consisting of two parts. It uses similar technology as bicycle helmet - hard shell outside with with hard styrofoam inside, to hold and protect the insides... | ||
| + | [[Image:Skica01a.jpg|200px]] [[Image:Skica01b.jpg|200px]] [[Image:Skica01c.jpg|200px]] | ||
| + | [[Image:Skica01d.jpg|200px]] [[Image:Skica01e.jpg|200px]] | ||
| - | == | + | [[Image:Skica04a.jpg|600px]] |
| + | |||
| + | [[Image:Skica04b.jpg|600px]] | ||
| + | |||
| + | [[Image:Skica04c.jpg|600px]] | ||
| + | |||
| + | == Fine design (industrial version) == | ||
After all the parts are precisely measured and consigured to fit together nicely... | After all the parts are precisely measured and consigured to fit together nicely... | ||
[[Image:F01.png|640px]] | [[Image:F01.png|640px]] | ||
| - | == | + | [[Image:Frida-render-inside.png|600px]] |
| + | |||
| + | [[Image:Frida-render-outside.png|600px]] | ||
| + | |||
| + | [[Image:Frida-render-pena.png|600px]] | ||
| + | |||
| + | |||
| + | == Fine design (do-it yourself version) == | ||
This is somewhat simpler, do-it yourself version which is much simpler and less expensive to produce... | This is somewhat simpler, do-it yourself version which is much simpler and less expensive to produce... | ||
| + | |||
| + | == Printed circuit board == | ||
| + | |||
| + | [[Image:Board31.png|600px]] | ||
